Centre plate between the 2 post to cover the hydraulic pipes and steel synchronizing ropes. It is the most common type of lift, but the plate can be considered an obstruction when removing gearboxes on a transmission jack, however this lift is suitable for low ceiling workshops.

Code: IMW2900
Product: 4 Ton manual release – Base plate
Data Sheet: Download product specs
Certification: ISO 9000/9001 CE
*Colours and designs may differ

Request a quotation

SG40-IMW2900-4 Ton manual release Base plate lifts

Features:	Benefits:
Manual release	When you have a power outage, the locks can still be released to lower the vehicle.
Floor plate design	Suitable for low ceiling workshop, and the height is not limited by an overhead beam. The lift can accommodate tall vehicles, roof racks and other roof-mounted features.
Cables	Stainless steel, strong and corrosion resistant.
Double cylinders	High strength chain drive system
Dynamic test 115% of the rate capacity	Ensures the hoist works correctly through its full cycle of operation
Static test: 150% of the rated capacity	Static load testing, to unsure the lifts can handle the recommended tonnage. Safety test.
Dual anti skidding safety device from column ladder to hydraulic seal protection	If the hydraulic system fails for some reason the vehicle on the lift will not fall, the lifts safety locks will lock into place to prevent any accidents.
Hydraulic system	Designed to avoid overload running
ABS control box, 24v low voltage control system	Conforms to ISO standards and electrical components of the lift.
High quality seals from Italy	Seals can withstand high pressure and mechanical stress.
Quality power rack	Ensures safety at all heights.
Conforms to CE requirements	The CE Mark on a product or machine identifies it as complying with all the of safety requirements established by the European Union.
Training available	Technicians can be professionally trained to use the machine and get the maximum benefit from it.
1 year warranty	The machine will be repaired if there are any factory faults and can be replaced if required.
Spares available	Should you have a breakdown you will not have to wait for your machine to be repaired. If there is anything we don’t have, we fly it in directly from the Suppliers.
Operational videos	Technicians can learn how to operate the machine by watching a video, which is easier and more simple than written instructions.

Important notice!

• Lift must be installed indoors.
• Approved installers must be used when installing lifts or warranty will be void.
• All electrical connections must be done by a qualified Electrician, and each unit requires a separate isolator.

Technical information

Lift
Lifting capacity: 4000kg
Maximum lifting height: 1900mm
Minimum lifting height: 85mm
Overall height: 2826mm
Overall width: 3426mm
Width between columns: 2803mm
Maximum vehicle width: 2775mm
Lifting time: 40s
Lowering time: 60s
Noise level: 70 dB(A0/1m
Average weight of package: 620kg

Electric motor
Voltage: 220V
Power: 2.2 Kw
Speed: 2850rpm

Power unit
Type: Gear
Flow rate: 4.8 cm³/g
Continuous working pressure: 170 bar – 190 bar
Peak pressure: 210 bar